Wine Closets
The 1,200 × 600 mm closet nobody uses, converted into a cooled wine store: insulated lining, a glass door, a bottle wall and a small split unit in the ceiling void.
What this one is
One page inside the by room and position group — a closet that becomes a cellar. What follows is how it meets the wall, how the rows are pitched, and what the drawing has to settle before anything is cut.
Where it goes
It is built into the joinery, flush with the surrounding panels.
It is part of a walk-in room, where the cabinet becomes the walling.
It is built with integrated cooling rather than a separate chiller.
Bottle fit and cradle pitch
Capacity for this model runs 60 – 400 bottles. If your count sits outside that band, the band moves rather than the room: the module count and the cradle pitch are what change, not the finish or the frame.
What the drawing fixes
Everything on the drawing comes back to four numbers: capacity 60 – 400 bottles; lead time 35 – 50 days. Change one of them and it is a different cabinet, drawn again rather than stretched. Closet conversion · Built-in · Cooled are the mounting conditions this one is drawn for.
Finish
Any of the 63 codes — see stainless steel finishes — and the lead time behind each one is quoted per project.
- Footprint
- From 0.8 m², typical closet 1,200 × 600 mm
- Lining
- 60 mm insulated stainless panel
- Capacity
- 60 – 400 bottles
- Door
- Framed glass, hinged or pivot, heated perimeter
- Cooling
- Small split unit in the ceiling void or an adjacent cupboard
- Humidity
- 55 – 75 % RH
- Finish
- Interior stainless or oak cradle, your choice
- Lead time
- 35 – 50 days
Lead times quoted per project.
More by room and position
Under-Stair Wine Cellars
Follows the rake · No wasted triangle
View
Dining Room Wine Storage
Within arm’s reach of the table
View
Kitchen Island Wine Storage
The end panel nobody uses
View
Made in our own factory in Shunde, Foshan: frame, finish, cradle and cooling in one workshop. Production runs 30 to 40 days after the deposit and is quoted per project. Crated for your forwarder; installation by your fitter to our drawing.
Before you order a wine closets
Where does the condenser go?
Into the ceiling void, an adjacent cupboard or through the wall to a service space. It is the first question we ask, because without somewhere for the condenser a closet cannot be cooled quietly.
Does the closet need to be stripped out first?
The existing linings come out and the floor stays. If the closet sits on a suspended timber floor we check the point load before specifying a bottle wall.
Can the door be a normal closet door?
It can, but then you lose the point of the room. A glass door in a stainless frame is what makes a closet read as a cellar rather than as a cupboard.
Send the wall, not the wish list
Three photographs and the bottle count is enough for a scheme and a fixed price.