Corner Wine Cabinets
A corner cabinet with a mitred glass front so the door faces the room at 45°, and shelves that run into the angle rather than stopping short of it.
What this one is
One page inside the by room and position group — angled front · no dead triangle. What follows is how it meets the wall, how the rows are pitched, and what the drawing has to settle before anything is cut.
Where it goes
It stands on the floor, so the plinth carries the load and the wall only has to stop it tipping.
It turns a corner, where two runs meet at an angle.
Bottle fit and cradle pitch
Capacity for this model runs 24 – 120 bottles. If your count sits outside that band, the band moves rather than the room: the module count and the cradle pitch are what change, not the finish or the frame.
Depth is 300 – 450 mm. The measurement that matters is the bottle, not the cabinet: a Burgundy bottle lying forward needs more than a Bordeaux one, and a magnum row needs more again.
What the drawing fixes
Everything on the drawing comes back to four numbers: width 600 – 1,800 mm on the face; height Up to 3,000 mm; depth 300 – 450 mm; capacity 24 – 120 bottles; lead time 30 – 40 days. Change one of them and it is a different cabinet, drawn again rather than stretched. Corner · Angled · Floor are the mounting conditions this one is drawn for.
Finish
Any of the 63 codes — see stainless steel finishes — and the lead time behind each one is quoted per project.
- Angle
- 45° face standard, other angles to order
- Width
- 600 – 1,800 mm on the face
- Height
- Up to 3,000 mm
- Depth
- 300 – 450 mm
- Capacity
- 24 – 120 bottles
- Shelving
- Radius-cut stainless cradle following the angle
- Glass
- Clear · tinted · fluted · Low-E on cooled units
- Lead time
- 30 – 40 days
Lead times quoted per project.
More by room and position
Ceiling Wine Racks
Hangs from the slab · Floor stays clear
View
Narrow & Shallow Wine Cabinets
From 260 mm deep · From 300 mm wide
View
Kitchen Wine Storage
Built into the kitchen, not bolted onto it
View
Made in our own factory in Shunde, Foshan: frame, finish, cradle and cooling in one workshop. Production runs 30 to 40 days after the deposit and is quoted per project. Crated for your forwarder; installation by your fitter to our drawing.
Before you order a corner wine cabinets
Does the corner lose storage?
No. The cradle is radiused into the angle, so the back corner holds bottles at an angle instead of being boxed off. That is roughly 15 % more capacity than a square cabinet pushed into the same corner.
Will the door open into the room?
It opens across the 45° face, so it needs less swing clearance than a 90° hinged door in the same corner. On tight corners we fit a pivot door instead.
Can it be cooled?
Yes, up to 60 bottles. Above that the corner shape works against even airflow and we would normally recommend a straight run plus a separate cooled unit.
Send the wall, not the wish list
Three photographs and the bottle count is enough for a scheme and a fixed price.